A full circle given as a radius
UnsupportedRefused. No file is produced.
What the converter says
an arc given as a radius cannot start and end in the same place
What triggers it
An arc that starts and ends in the same place goes all the way round, and a radius alone cannot say where its centre is: every circle of that radius through the point would do.
G2 X100.000 Y100.000 I150.000 J100.000How to fix it
Cut the circle as two half-circles, each with its own end point, or give the centre rather than the radius.
Applies to
- G2: clockwise arcsVerified