A cut deeper than the panel is thick

What the converter says

cutting 25 deep into a panel 18 thick goes right through it

Code: mpr_depth_past_underside

What triggers it

The path is cut deeper than the panel thickness, so it goes right through. That is written as a cut reaching the underside, which is how woodWOP says a through cut.

G0 X100 Y100 Z25 T43
G1 X200 Y100

Example that triggers it

How to fix it

Nothing needs fixing if the cut was meant to go through. If it was not, check the panel thickness in the header.

Applies to

• G1: straight cuts and plungesUnverified

Messages this command can produce

• Cutting before any depth was set
• Straight cut not yet run from our output
• Feed converted to a class
• No cutting moves found
• Depth change after the first depth